Re: Switch-mode Supply For Bug Zapper Fwd
K |
K |
||
| Zeile 1: | Zeile 1: | ||
| − | <br>To: High Voltage | + | <br>To: High Voltage list Subject: Re: Switch-mode provide for [https://xn--9i1bv8kw7jsnma.com/bbs/board.php?bo_table=free&wr_id=1093856 rechargeable bug zapper] [https://amborettoamericas.com/liquid/heat-transfer-liquids-hot-oil/ bug zapper for camping] (fwd) You need the components for the steel you intend to make use of. Differing types have totally different losses. You obtain this from the mfgr. Digi-Key has some inexpensive IR sort emitters & detectors. Have the fly crawl a distance, [https://wiki.laduni.id/User:AntoniettaEig cordless bug zapper] zapper for patio like 4-6 inches inside the tube, after which, he triggers the IR beam which controls the zapper. A small single ended NST works nice for this software. The current will burn them right up. The fly hits the IR beam at the 1/2 mid-approach level which energizes a small grid in each route. The midpoint has a bit 2 inches lengthy with no grid. They grow to be trapped and can't exit either direction with out getting zapped. You may additionally use a 600 Ohm to 10K audio xmfr. They make nice HV sparks working in a pulsed mode. If the time duration is short, like 1-2 sec, they may additionally charge a cap rectified with a 1/2 wave diode in a short while period. Then the charged cap waits for the fly. The charging cycle happens each 5 minutes and is managed by a 555 IC chip --- a small relay controls the power section. You set sugar crystals in the tube and at the top of the tube use a small glass test tube so you can see your accumulated flies to regulate the time durations. The flies will accumulate and then try to exit the charged grid part. The one now we have uses a traditional laminated iron, 50Hz transformer. I'd like, so I'm looking at making a switchmode model. 2) Ditto for sizing the parts for the snubber. HV rectification and that I'd want a string of high-pace diodes.<br><br><br><br>Dynatrap makes [https://elearnportal.science/wiki/User:SerenaHillier29 insect zapper] traps that work on the same principle as others. They entice flying bugs with warmth and carbon dioxide, then catch them and forestall them from escaping. For warmth, they use a fluorescent ultra-violet bulb, which additionally emits [https://gls-fun.com/cat/cat/ape/p12/apeboard_plus.cgi outdoor bug zapper]-attracting light. The primary difference is that they don’t use propane to create carbon dioxide (CO2). Instead, they use a particular process. More on that under. Since they don’t use propane, which means no need to purchase and [https://assessoriaautomotiva.com/index.php/2023/09/25/solar-energy-benefits-going-green-and-saving-green/ ZappifyBug.com] alter cylinders, and best of all, no upkeep issues with clogged lines or failure of the propane to mild-issues that hassle many different traps. You still need to plug them in, so you’ll need an outside outlet and an extension cord if you'd like dangle the lure more than 7-10 toes from the outlet. The DT2000XL model is more expensive than the DT1000 model, but it’s greater, with a stronger fan and brilliant light, and might attract bugs from farther away, with coverage as much as an acre for the DT2000XL and a half-acre for the DT1000, according to the manufacturer.<br><br><br><br>If you’ve undoubtedly decided not to buy a propane mosquito lure, that is the following neatest thing. I’ll record the professionals and cons of the 2 fashions collectively, as a result of they’re similar. Its initial cost is cheaper than propane traps. It doesn’t require the trouble and expense of replacing propane tanks. It catches other bugs moreover mosquitoes, although that’s not at all times good if they’re beneficial ones. You need to use it indoors or outdoors. The one sound is the quiet humming of the fan and there’s no odor. It’s safe for pets, kids and the environment, because it uses no insecticides. The large one: it doesn’t essentially kill mosquitoes particularly, so it's possible you'll get more moths or different issues as an alternative. You’ll need to mount it about 5 to 6 feet off the bottom. One mannequin, the DT1200, comes with its personal hanger, however otherwise, it wants a tree department, publish, wall, fence, and so forth. to hang or sit on.<br><br><br><br>If you employ it outdoors, it may have some rain shelter to prevent water from moving into the accumulating area. It needs an outlet 7-10 toes away or an extension cord. It’s difficult to empty with out letting some bugs escape. The claim that it emits an efficient amount of CO2 has been questioned. Like all traps, it needs placed in a very good location, shady and sheltered, the place mosquitoes can find it, however not where you’ll be bothered by them. The lights in the top of the entice emit warmth and ultraviolet rays, which attract mosquitoes in addition to other insects, notably moths at evening. There are openings beneath the lights the place bugs can fly in. Once inside, they’re sucked down by the fan’s air currents into the retaining cage under, the place they’re unable to escape and die within a day. Unfortunately, mild and warmth are just two of the things that attract mosquitoes, since what they’re mainly in search of are folks to bite.<br><br><br><br>Carbon dioxide is what they really search, since we and other animals emit it once we exhale. Mosquitoes know that if they follow that vapor trail, [http://www.vokipedia.de/index.php?title=Benutzer:TrentChambless vokipedia.de] there shall be a tasty animal on the opposite finish, ready to be bitten. To supply carbon dioxide, the Dynatrap makes use of a broad form of funnel above the fan, coated with titanium dioxide (TiO2). The producer claims that when the ultraviolet light reacts with the TiO2, "a photocatalytic reaction takes place that produces carbon dioxide." This is the method it makes use of, instead of burning propane like other traps. However, when the University of Wisconsin tried to measure the amount of carbon dioxide emitted, they reported that they detected none in any respect. One reviewer pointed out that the TiO2 surface would want coated with a source of carbon, like mud or useless bugs, to ensure that the method to make carbon dioxide. See the overview here (scroll right down to Dr. Marsteller’s remark).<br> |
Version vom 19. September 2025, 00:18 Uhr
To: High Voltage list Subject: Re: Switch-mode provide for rechargeable bug zapper bug zapper for camping (fwd) You need the components for the steel you intend to make use of. Differing types have totally different losses. You obtain this from the mfgr. Digi-Key has some inexpensive IR sort emitters & detectors. Have the fly crawl a distance, cordless bug zapper zapper for patio like 4-6 inches inside the tube, after which, he triggers the IR beam which controls the zapper. A small single ended NST works nice for this software. The current will burn them right up. The fly hits the IR beam at the 1/2 mid-approach level which energizes a small grid in each route. The midpoint has a bit 2 inches lengthy with no grid. They grow to be trapped and can't exit either direction with out getting zapped. You may additionally use a 600 Ohm to 10K audio xmfr. They make nice HV sparks working in a pulsed mode. If the time duration is short, like 1-2 sec, they may additionally charge a cap rectified with a 1/2 wave diode in a short while period. Then the charged cap waits for the fly. The charging cycle happens each 5 minutes and is managed by a 555 IC chip --- a small relay controls the power section. You set sugar crystals in the tube and at the top of the tube use a small glass test tube so you can see your accumulated flies to regulate the time durations. The flies will accumulate and then try to exit the charged grid part. The one now we have uses a traditional laminated iron, 50Hz transformer. I'd like, so I'm looking at making a switchmode model. 2) Ditto for sizing the parts for the snubber. HV rectification and that I'd want a string of high-pace diodes.
Dynatrap makes insect zapper traps that work on the same principle as others. They entice flying bugs with warmth and carbon dioxide, then catch them and forestall them from escaping. For warmth, they use a fluorescent ultra-violet bulb, which additionally emits outdoor bug zapper-attracting light. The primary difference is that they don’t use propane to create carbon dioxide (CO2). Instead, they use a particular process. More on that under. Since they don’t use propane, which means no need to purchase and ZappifyBug.com alter cylinders, and best of all, no upkeep issues with clogged lines or failure of the propane to mild-issues that hassle many different traps. You still need to plug them in, so you’ll need an outside outlet and an extension cord if you'd like dangle the lure more than 7-10 toes from the outlet. The DT2000XL model is more expensive than the DT1000 model, but it’s greater, with a stronger fan and brilliant light, and might attract bugs from farther away, with coverage as much as an acre for the DT2000XL and a half-acre for the DT1000, according to the manufacturer.
If you’ve undoubtedly decided not to buy a propane mosquito lure, that is the following neatest thing. I’ll record the professionals and cons of the 2 fashions collectively, as a result of they’re similar. Its initial cost is cheaper than propane traps. It doesn’t require the trouble and expense of replacing propane tanks. It catches other bugs moreover mosquitoes, although that’s not at all times good if they’re beneficial ones. You need to use it indoors or outdoors. The one sound is the quiet humming of the fan and there’s no odor. It’s safe for pets, kids and the environment, because it uses no insecticides. The large one: it doesn’t essentially kill mosquitoes particularly, so it's possible you'll get more moths or different issues as an alternative. You’ll need to mount it about 5 to 6 feet off the bottom. One mannequin, the DT1200, comes with its personal hanger, however otherwise, it wants a tree department, publish, wall, fence, and so forth. to hang or sit on.
If you employ it outdoors, it may have some rain shelter to prevent water from moving into the accumulating area. It needs an outlet 7-10 toes away or an extension cord. It’s difficult to empty with out letting some bugs escape. The claim that it emits an efficient amount of CO2 has been questioned. Like all traps, it needs placed in a very good location, shady and sheltered, the place mosquitoes can find it, however not where you’ll be bothered by them. The lights in the top of the entice emit warmth and ultraviolet rays, which attract mosquitoes in addition to other insects, notably moths at evening. There are openings beneath the lights the place bugs can fly in. Once inside, they’re sucked down by the fan’s air currents into the retaining cage under, the place they’re unable to escape and die within a day. Unfortunately, mild and warmth are just two of the things that attract mosquitoes, since what they’re mainly in search of are folks to bite.
Carbon dioxide is what they really search, since we and other animals emit it once we exhale. Mosquitoes know that if they follow that vapor trail, vokipedia.de there shall be a tasty animal on the opposite finish, ready to be bitten. To supply carbon dioxide, the Dynatrap makes use of a broad form of funnel above the fan, coated with titanium dioxide (TiO2). The producer claims that when the ultraviolet light reacts with the TiO2, "a photocatalytic reaction takes place that produces carbon dioxide." This is the method it makes use of, instead of burning propane like other traps. However, when the University of Wisconsin tried to measure the amount of carbon dioxide emitted, they reported that they detected none in any respect. One reviewer pointed out that the TiO2 surface would want coated with a source of carbon, like mud or useless bugs, to ensure that the method to make carbon dioxide. See the overview here (scroll right down to Dr. Marsteller’s remark).