Re: Switch-mode Supply For Bug Zapper Fwd
K |
K |
||
| Zeile 1: | Zeile 1: | ||
| − | <br>To: High Voltage | + | <br>To: High Voltage list Subject: Re: Switch-mode provide for [http://git.gkcorp.com.vn:16000/stephengourgau cordless bug zapper] zapper (fwd) You want the factors for the steel you intend to use. Differing types have completely different losses. You obtain this from the mfgr. Digi-Key has some cheap IR type emitters & detectors. Have the fly crawl a distance, like 4-6 inches contained in the tube, after which, he triggers the IR beam which controls the zapper. A small single ended NST works nice for this software. The present will burn them proper up. The fly hits the IR beam on the 1/2 mid-means point which energizes a small grid in every route. The midpoint has a section 2 inches lengthy with no grid. They turn into trapped and can't exit both route with out getting zapped. You possibly can additionally use a 600 Ohm to 10K audio xmfr. They make good HV sparks working in a pulsed mode. If the time duration is short, like 1-2 sec, they could also charge a cap rectified with a 1/2 wave diode in a short while interval. Then the charged cap waits for the fly. The charging cycle happens every 5 minutes and is managed by a 555 IC chip --- a small relay controls the facility part. You place sugar crystals in the tube and at the top of the tube use a small glass check tube so you'll be able to see your accumulated flies to adjust the time intervals. The flies will accumulate after which try to go out the charged grid section. The one now we have makes use of a conventional laminated iron, 50Hz transformer. I'd like, so I'm looking at making a switchmode version. 2) Ditto for [https://sciencewiki.science/wiki/User:KarryMolnar buy bug zapper] sizing the parts for the snubber. HV rectification and that I'd need a string of high-velocity diodes.<br><br><br><br>Dynatrap makes insect traps that work on the same principle as others. They appeal to flying bugs with warmth and carbon dioxide, then catch them and stop them from escaping. For warmth, they use a fluorescent extremely-violet bulb, which also emits bug-attracting light. The primary difference is that they don’t use propane to create carbon dioxide (CO2). Instead, they use a special process. More on that beneath. Since they don’t use propane, that means no need to [https://gitea.jobiglo.com/ednageoghegan6 buy bug zapper] and alter cylinders, and [https://wellcat.cz/2021/09/platnost-nevycerpanych-permanentek/ buy bug zapper] better of all, no upkeep problems with clogged lines or failure of the propane to light-points that bother many other traps. You continue to must plug them in, so you’ll need an outside outlet and an extension cord if you need dangle the trap greater than 7-10 toes from the outlet. The DT2000XL model is dearer than the DT1000 model, but it’s greater, with a stronger fan and vivid light, and can entice bugs from farther away, with coverage as much as an acre for the DT2000XL and a half-acre for the DT1000, in accordance with the manufacturer.<br><br><br><br>If you’ve definitely decided not to buy a propane mosquito entice, that is the following best thing. I’ll list the pros and cons of the two fashions collectively, because they’re related. Its initial price is cheaper than propane traps. It doesn’t require the trouble and expense of changing propane tanks. It catches different bugs apart from mosquitoes, although that’s not always good if they’re helpful ones. You should use it indoors or outdoors. The one sound is the quiet humming of the fan and there’s no odor. It’s secure for pets, youngsters and the setting, Zappify [https://git.manabo.org/domenichertzog outdoor bug zapper] Zapper because it makes use of no insecticides. The massive one: it doesn’t essentially kill mosquitoes particularly, so chances are you'll get more moths or other things as an alternative. You’ll must mount it about 5 to six ft off the ground. One model, the DT1200, comes with its personal hanger, but in any other case, it wants a tree branch, put up, wall, fence, etc. to hold or sit on.<br><br><br><br>If you utilize it outdoors, it might have some rain shelter to stop water from stepping into the accumulating area. It wants an outlet 7-10 toes away or an extension cord. It’s tricky to empty with out letting some bugs escape. The claim that it emits an efficient quantity of CO2 has been questioned. Like all traps, it needs placed in a great location, shady and sheltered, where mosquitoes can find it, however not the place you’ll be bothered by them. The lights in the top of the lure emit warmth and ultraviolet rays, which appeal to mosquitoes as well as different insects, notably moths at evening. There are openings under the lights the place bugs can fly in. Once inside, they’re sucked down by the fan’s air currents into the retaining cage below, where they’re unable to escape and die inside a day. Unfortunately, light and warmth are simply two of the things that attract mosquitoes, since what they’re primarily looking for are folks to chunk.<br><br><br><br>Carbon dioxide is what they actually seek, since we and other animals emit it once we exhale. Mosquitoes know that in the event that they follow that vapor path, there shall be a tasty animal on the opposite finish, able to be bitten. To supply carbon dioxide, the Dynatrap makes use of a broad kind of funnel above the fan, coated with titanium dioxide (TiO2). The manufacturer claims that when the ultraviolet mild reacts with the TiO2, "a photocatalytic reaction takes place that produces carbon dioxide." This is the process it makes use of, as a substitute of burning propane like different traps. However, when the University of Wisconsin tried to measure the amount of carbon dioxide emitted, they reported that they detected none in any respect. One reviewer identified that the TiO2 floor would wish coated with a supply of carbon, like dust or dead bugs, to ensure that the method to make carbon dioxide. See the evaluation here (scroll down to Dr. Marsteller’s comment).<br> |
Version vom 14. November 2025, 06:12 Uhr
To: High Voltage list Subject: Re: Switch-mode provide for cordless bug zapper zapper (fwd) You want the factors for the steel you intend to use. Differing types have completely different losses. You obtain this from the mfgr. Digi-Key has some cheap IR type emitters & detectors. Have the fly crawl a distance, like 4-6 inches contained in the tube, after which, he triggers the IR beam which controls the zapper. A small single ended NST works nice for this software. The present will burn them proper up. The fly hits the IR beam on the 1/2 mid-means point which energizes a small grid in every route. The midpoint has a section 2 inches lengthy with no grid. They turn into trapped and can't exit both route with out getting zapped. You possibly can additionally use a 600 Ohm to 10K audio xmfr. They make good HV sparks working in a pulsed mode. If the time duration is short, like 1-2 sec, they could also charge a cap rectified with a 1/2 wave diode in a short while interval. Then the charged cap waits for the fly. The charging cycle happens every 5 minutes and is managed by a 555 IC chip --- a small relay controls the facility part. You place sugar crystals in the tube and at the top of the tube use a small glass check tube so you'll be able to see your accumulated flies to adjust the time intervals. The flies will accumulate after which try to go out the charged grid section. The one now we have makes use of a conventional laminated iron, 50Hz transformer. I'd like, so I'm looking at making a switchmode version. 2) Ditto for buy bug zapper sizing the parts for the snubber. HV rectification and that I'd need a string of high-velocity diodes.
Dynatrap makes insect traps that work on the same principle as others. They appeal to flying bugs with warmth and carbon dioxide, then catch them and stop them from escaping. For warmth, they use a fluorescent extremely-violet bulb, which also emits bug-attracting light. The primary difference is that they don’t use propane to create carbon dioxide (CO2). Instead, they use a special process. More on that beneath. Since they don’t use propane, that means no need to buy bug zapper and alter cylinders, and buy bug zapper better of all, no upkeep problems with clogged lines or failure of the propane to light-points that bother many other traps. You continue to must plug them in, so you’ll need an outside outlet and an extension cord if you need dangle the trap greater than 7-10 toes from the outlet. The DT2000XL model is dearer than the DT1000 model, but it’s greater, with a stronger fan and vivid light, and can entice bugs from farther away, with coverage as much as an acre for the DT2000XL and a half-acre for the DT1000, in accordance with the manufacturer.
If you’ve definitely decided not to buy a propane mosquito entice, that is the following best thing. I’ll list the pros and cons of the two fashions collectively, because they’re related. Its initial price is cheaper than propane traps. It doesn’t require the trouble and expense of changing propane tanks. It catches different bugs apart from mosquitoes, although that’s not always good if they’re helpful ones. You should use it indoors or outdoors. The one sound is the quiet humming of the fan and there’s no odor. It’s secure for pets, youngsters and the setting, Zappify outdoor bug zapper Zapper because it makes use of no insecticides. The massive one: it doesn’t essentially kill mosquitoes particularly, so chances are you'll get more moths or other things as an alternative. You’ll must mount it about 5 to six ft off the ground. One model, the DT1200, comes with its personal hanger, but in any other case, it wants a tree branch, put up, wall, fence, etc. to hold or sit on.
If you utilize it outdoors, it might have some rain shelter to stop water from stepping into the accumulating area. It wants an outlet 7-10 toes away or an extension cord. It’s tricky to empty with out letting some bugs escape. The claim that it emits an efficient quantity of CO2 has been questioned. Like all traps, it needs placed in a great location, shady and sheltered, where mosquitoes can find it, however not the place you’ll be bothered by them. The lights in the top of the lure emit warmth and ultraviolet rays, which appeal to mosquitoes as well as different insects, notably moths at evening. There are openings under the lights the place bugs can fly in. Once inside, they’re sucked down by the fan’s air currents into the retaining cage below, where they’re unable to escape and die inside a day. Unfortunately, light and warmth are simply two of the things that attract mosquitoes, since what they’re primarily looking for are folks to chunk.
Carbon dioxide is what they actually seek, since we and other animals emit it once we exhale. Mosquitoes know that in the event that they follow that vapor path, there shall be a tasty animal on the opposite finish, able to be bitten. To supply carbon dioxide, the Dynatrap makes use of a broad kind of funnel above the fan, coated with titanium dioxide (TiO2). The manufacturer claims that when the ultraviolet mild reacts with the TiO2, "a photocatalytic reaction takes place that produces carbon dioxide." This is the process it makes use of, as a substitute of burning propane like different traps. However, when the University of Wisconsin tried to measure the amount of carbon dioxide emitted, they reported that they detected none in any respect. One reviewer identified that the TiO2 floor would wish coated with a supply of carbon, like dust or dead bugs, to ensure that the method to make carbon dioxide. See the evaluation here (scroll down to Dr. Marsteller’s comment).